Renewable Energy · Basic level · 3 min read ·
What is the National Interconnected System (SIN)?
The Sistema Interconectado Nacional (SIN), Colombia's national interconnected system, is the grid linking power plants with users across most of the country: plants, transmission lines, substations and distribution networks. Energy that enters at one point can be used somewhere far away. Regions not connected to it are the Non-Interconnected Zones.
In 30 seconds
- It connects generators and users in a single national grid.
- XM runs it in real time, balancing what is produced and what is consumed at every moment.
- About half the territory is outside the SIN, though only a small share of the population lives there.
Why should you care?
A solar system connected to the SIN doesn't have to store its energy: whatever isn't used on site can go into the grid. That connection is the basis of surplus energy.
- You understand where a project's surplus energy goes.
- You know why a project connected to the SIN works differently from an isolated one.
- You can place the grid's parts: transmission, distribution and grid operator.
Think of it as a whole country's water network
Imagine every tank and pipe in the country were joined. Water entering a reservoir could come out of a tap in another city. The SIN is that for electricity: many sources, one system of pipes.
How does the SIN work?
- 1
Plants generate
Hydro, thermal, solar and wind plants feed energy into the grid.
- 2
Transmission carries it far
High-voltage lines move large blocks of energy between regions.
- 3
Distribution brings it close
Local networks, at lower voltage, carry it to homes and businesses.
- 4
An operator balances it all
XM, as system operator, matches generation to demand minute by minute.
An example with numbers
A 10 kWp system connected to the SIN produces 36 kWh in a day (10 × 4.5 peak sun hours × 0.8), as in the irradiance lesson. The site uses 20 kWh while the sun is out. Illustrative figures, unrelated to any project.
| Energy produced in the day | 36 kWh |
|---|---|
| Used on site | 20 kWh |
| Delivered to the SIN (36 − 20) | 16 kWh |
| Drawn from the SIN at night | Whatever the site needs |
Thanks to the SIN, the 16 spare kWh aren't lost: another user consumes them. And at night, with no sun, the site still gets energy from the grid.
Where do you see it at Circular Urban?
Solar projects connect to the SIN through the local grid operator's network. The sheet shows where the energy goes: what the client consumes and the surplus delivered to the grid.
- Each solar project's sheet, under How the operation flows.
- Each solar project's sheet, under Energy Production.
What changes in your finances once you get it
You follow the energy
You know a project can sell or deliver to the grid whatever its client doesn't use.
You tell connected from isolated
A project in a Non-Interconnected Zone has different rules and risks from one connected to the SIN.
You understand the grid's limits
You know the grid may, at times, not take all the energy, and that this is called curtailment.
Common mistakes
- Myth
Panels connected to the SIN need batteries to work.
- In reality
Not necessarily: the grid takes the daytime surplus and supplies energy at night.
- Myth
Energy from a solar rooftop goes straight to the neighbor who buys it.
- In reality
It enters the grid and mixes with the rest of the system. What gets recorded is how much was delivered.
- Myth
All of Colombia is connected to the SIN.
- In reality
About half the territory is in Non-Interconnected Zones, supplied by local solutions.
Test yourself
A system produces 50 kWh in a day and the site uses 35 kWh while the sun is out. How much energy goes to the SIN?
Keep learning
Helps to know first
This content is educational. Every participation carries risks inherent to the project, including the possibility of partial or total loss, and results are subject to each project's actual performance.

